Jeremy,   I understand your plight. perhaps there is a way to get some steel 1x1/4 and bolt through to the engine and attach them to the ...   07-24-2007 11:35 pm

Get a copy because a picture of my JH is featured in that article. Its only one picture but hey????/ Also, check out the values ...   07-04-2007 12:05 am

I hope this clears up this topic once and for all. I bought a Haynes Vauxhall Magnum 1800& 2300 owners workshop manual from a guy ...   03-09-2007 11:54 pm

I hope this clears up this topic once and for all. I bought a Haynes Vauxhall Magnum 1800& 2300 owners workshop manual from a guy ...   03-09-2007 11:54 pm

While looking for some small parts I found the VIN dash tag for 15011 in a box of parts that I bought off of Ebay. I ...   03-05-2007 09:56 pm

First off Happy New Year to everybody. Here are the GTs that I presently own: GT 30131  its white has about 70,000 miles on it. Has ...   01-01-2007 04:51 pm

JH 14966 RHD, up until Rick Willard got his RHD this one seemed to be the only one in the States. It is the mustard ...   12-02-2006 01:52 am

I'll list the ones I stripped for parts first: GT 30249 completely rusted out but it only had 26,000 miles on it I will be putting ...   11-29-2006 03:47 pm

Concerning Michael's carb problem I would suspect since the gas tank is rusty it is clogging up the gas lines and gas filters.                                                 Joseph ...   07-25-2006 12:42 am

Hey Michael, Use the phone number I supplied for Renu they did a great job and I am very happy. I am confident that my tank ...   07-25-2006 12:30 am

Hey Michael, Use the phone number I supplied for Renu they did a great job and I am very happy. I am confident that my tank ...   07-25-2006 12:30 am

Hi Patrick, If you are still looking for a GT to purchase I have 3 of them in various conditions and prices. They located in N.W. ...   06-06-2006 04:11 am

Brett & Bert,          Dave Bean at www.davebean.com has the anti-popping spacers (ask for Ken Grey). They have done the job for me. No more popping ...   06-06-2006 04:03 am

Hi Kurt,             Could be a clogged oil cooler. This is something I suspect. The fact remains the same, my oil pressure has never ever gone ...   05-29-2006 07:39 pm

Oops, I should have said "I feel very uncomfortable when..."                             Joe ...   05-29-2006 05:07 am

Hi John,                 Thanks for the reply. I know about viscosity and how it changes when the engine is warm. My engine just started to read ...   05-29-2006 05:04 am

On later pondering I figured out that the engine expanded and coaused the belt to become tighter. ofcourse, one might say , doesn't the belt ...   05-29-2006 12:03 am

I have a question:::          What is the oil gauge telling you when the water temp gauge reads past the 1/2 way mark??? I just installed ...   05-28-2006 11:20 pm

I just got my tank from that outfit in Pennslyvannia, Renu, they tear it apart and coat the inside and outside. Cost was $350.00 plus ...   05-16-2006 12:01 am

TIM, I also concur with Greg about you reconsider NOT leaving this board. I know Tim from another board and his knowlege is inexhaustable. It would ...   05-15-2006 11:41 pm

One must keep in mind that about 1.5 quart of oil is always in the car via the oil cooler and oil lines. I usually change ...   05-15-2006 11:28 pm

Thanks Mitch,  Are you planning on coming to J2006 in the great state of Illinois???                               Joe   ...   02-06-2006 06:47 pm

Hello Everyone,                    I am trying to locate that company that does the wood dash replacement. I know its start with the letter "M" but I ...   02-06-2006 06:24 pm

Hi John,                I don't know if you made the decision of who you are going to use to transport your JH but I want to ...   02-04-2006 07:23 pm

Duh, I forgot about getting the trans seal off. Its fairly easy I use a screwdriver and pivot the screwdriver on the rear trans shaft. ...   08-18-2005 12:04 am

Hi Rory,           First drain the tranny using a 26mm box wrench on the plug at the bottom and use the same wrench for the fill ...   08-17-2005 11:57 pm

If you are worried about your cam gears, buy the half-moon type from Dave Bean. Sure they are a little expensive but you get a ...   08-05-2005 04:29 pm

I bought a GT from a guy in California who cut a hole in the blower box on the bulkhead and used some "L" shaped brackets ...   07-25-2005 11:56 pm

HI Tim,                I use an Interstate 51R and it fits perfectly in the battery tray of my GT but I am sure it will fit ...   05-24-2005 02:38 pm

Here is a pic of the Dunlops in question. They came with my GT when I bought it. They do have those long bolts you ...   05-18-2005 10:38 pm

               Here is the COMPLETE copy of the  VIN for    JH # 17777. I hope this works this time.                                 Joe ...   05-09-2005 11:05 pm

HI Greg,           here is the window sticker for VIN 17777 total price is $7275.00. I bought this sales sheet off Ebay.                                   Joseph Mazurk                                     Chicago, IL ...   05-09-2005 10:42 pm

The correct color name is Moss Green. That was the color of my first JH wayyyyyyyy back in 1973. Moss Green, when you first approach ...   04-22-2005 02:57 am

Mark,                  My scanner works but the pic is toooooooooooooooo big. If you have a copy of the April 1972 Road & Track there you find ...   04-14-2005 06:52 pm

Actually Mark, the first 200 JHs' had a completely different wheel. I have a factory photo of the first JHs' off the production line. If ...   04-12-2005 10:23 pm

Sorry about the repeat. Here is a pic of my set-up.                             Joseph Mazurk                               Chicago, IL ...   03-30-2005 12:33 am

  Hey Brett,              I, too installed mine through the middle. The same set-up as the Stroms. The only thing extra I had to do was cap ...   03-30-2005 12:13 am

  Hey Brett,              I, too installed mine through the middle. The same set-up as the Stroms. The only thing extra I had to do was cap ...   03-30-2005 12:13 am