| ||||
|
Posts by rederic48 | |
---|---|
8 posts | Showing posts 1-8 of 8 |
Engine & Transmission > 2.2 conrods (2 replies - 1850 views) Many thanks Tim for the very informative information.
Regards ... 01-13-2023 08:30 am Engine & Transmission > 2.2 conrods (2 replies - 1850 views) Hello
I am building a 2.2 engine and was wandering if their is a difference between the 2.0 standard conrod and that required for a 2.2 ... 01-09-2023 10:06 am Brakes > Silicone brake fluid quantity (2 replies - 2365 views) Hello
I am intending to overhaul the brake system on my 73 JH and intend to change to silicone brake fluid. Anybody know what quantity I ... 01-10-2022 04:29 pm Cooling > Water pump pulley position (4 replies - 3424 views) Hello
I needed to change my water pump on an early engine and found an acceptable one amongst my spares. However, the v belt pully is ... 12-30-2021 03:57 pm Engine & Transmission > Piston compression cold (8 replies - 5435 views) Success at last. Swapped carbs from my GT, which I knew were working perfectly, to the JH. Car started after a few cranks and full ... 10-30-2021 04:01 pm Engine & Transmission > Piston compression cold (8 replies - 5435 views) I retried with full throttle and the cylinders came out as
95: 105: 95: 100. Still with cold non starting engine.
Spark plugs are slightly wet and ... 10-26-2021 03:11 pm Engine & Transmission > Piston compression cold (8 replies - 5435 views) Hello
Due to non starting after doing a decoke and inlet valves change I decided to check on the compression for the four piston chambers. I ... 10-25-2021 04:26 pm Ignition > Valve clearance with paper gasket (4 replies - 3958 views) Hello
I have a earlier (73) engine which does not have the revised oil connection O ring between cam carrier and cylinder head. I have recently ... 09-21-2021 01:52 pm | |
Current time is 04:18 pm |