Finally got 14932 running after it sat in my neighbor's yard for 20 years. Became something of a Stromberg RandR expert after removing and replacing ...   08-02-2021 09:11 pm

My carbon canister is shot. A couple questions: 1. If I remove it do I just plug vacuum line from manifold and vapor(?)one coming from tank? ...   02-22-2021 09:46 pm

Ok. Full story. 2 years ago I ordered Thackery(spring) Washers from the Club Garage. The Camp Fire intervened and I laid off the car and ...   02-22-2020 01:16 am

Thanks I have the spring washers and you answered my main question without my asking it. The washers go both sides of the spring washers. ...   02-21-2020 01:01 am

When mounting Strombergs with Thackery Washers, are there any washers included on either side of the Thackery washers? Been a couple years since I took ...   02-19-2020 09:14 pm

Thanks for the reply. I'll use the Permatex idea. I think I figured it out. I installed grommet/donut(all new rubber pieces on original 74 filler ...   05-17-2019 02:27 am

I have re-installed the gas tank with rubber filler tube connected to the neck on the gas tank and through the body grommet. I cannot ...   05-16-2019 01:32 am

When re-building my Strombergs I found one with and one without the small "plastic washer" described on the back of the instruction sheet in the ...   10-31-2018 11:43 pm

Thanks for quick reply. New to store and didn't look far enough. They are on the way. ...   10-12-2018 10:18 pm

Has anyone found a good source for the "Thackeray" or "spring" washer used in carb. plate to intake manifold connection. Are the nuts just Nyloc ...   10-12-2018 01:27 am

I am starting a resurrection of a 1974 Jensen Healy #14932. I had my first lesson with the gas tank. I saw a pinhole leak ...   05-25-2018 09:02 pm