Need help. Just had a cam belt tensioner, from Martin Robey and a blue belt from the club store installed. Now the belt travels about ...   07-29-2017 12:33 am

What is the difference between this one and the cam belt tensioner sold by Martin Robey. ...   07-23-2017 08:37 pm

Peening the bush was pretty easy. I used two needle nose vice grips to hold the upper and lower brackets with the rubber in the ...   01-22-2017 01:06 am

Do you remember the size of the poly pack you got from mcmaster-Carr? Also what thrust bearing do you recommend. Appreciate your help. ...   12-18-2016 03:44 pm

It looks like i have the same issue with oil pooling in the block pockets.i have been cleaning the areas continually looking for the leaks. ...   12-17-2016 08:12 pm

Thanks. It ĺooks like welding is a good option. ...   12-17-2016 01:42 pm

Thanks. Felt around up there. Did feel something, must be the clip. So far no response from anyone about having a pivot pin they would ...   12-15-2016 11:06 pm

Thanks. Remember how long it took you for the Repair? I'm thinking 3-4 hours if all goes well. ...   12-15-2016 11:14 am

Thanks for the info. Will start planning. ...   12-15-2016 01:13 am

I think we are talking about the same thing. The 5 speed lever pivot that connects the clutch release lever. I did think about welding ...   12-15-2016 12:18 am

Well as luck has it. Changed my clutch cable only to find the clutch pivot pin broken. It is still working but it is very ...   12-14-2016 07:40 pm

Finally three days and the front springs and shocks are installed. The PO rounded most of the nuts on the front end. Between a file, ...   11-01-2016 09:52 pm

Just back from a 50 mile run. It was like riding on a firm marshmallow cloud. What a difference. Thank you Greg. Can't wait to ...   10-25-2016 12:21 am

Just changed the rear shocks and springs on little red. Got them from Greg. They look great but as everyone said took a while to ...   10-24-2016 08:59 pm

I know it's an old thread. But great info. Worked perfect and saved me a lot of learning curve grief. ...   10-07-2016 05:43 pm

Changed the sender and everything is back to normal. Thanks for your help. ...   07-19-2016 02:19 am

Thanks. Have one on order from Delta. Will change this coming week. ...   07-16-2016 02:45 pm

After a little research it might be the water temp sending unit. Has anyone replaced one of these? ...   07-15-2016 07:22 pm

Up to today little red ran just under the halfway point on the temp gauge. Today after an oil change on the ride home the ...   07-15-2016 06:37 pm

1974 JH5  VIN #19029  Engine#  B7410-9836 Dellorto 45’S - Getrag  5 speed - Pertronix ignition - 3 core aluminum radiator Front and rear sway bars – Roll ...   05-04-2016 09:51 pm