Thanks Fletcher, I'll find out this week by asking a couple of very reliable machine shops in my area and see what they say. Will keep ...   12-22-2013 05:28 pm

Thank you Kurt, hope someone else have some experience in the matter and can add some light on the subject. ...   12-17-2013 08:44 pm

Does any one knows whats involved in using the 318 chrysler bearing in the 907? ...   12-17-2013 01:35 am

Thanks guys, you have no idea what your help means to me.  The rivets in the Floor Pans are about one inch apart, I'm almost to ...   12-09-2013 09:39 pm

the floor pans where made out of aluminum a while back by the PO and riveted to the rails, but the rails are rusting, not ...   12-07-2013 02:51 am

I know that it has been a topic of discussion before, but I just found out that the 318 crankshaft journal is the same size ...   12-07-2013 02:44 am

Hi guys.  I'm in the process of totally rebuilding my JH and just found out that the "rails" under the floor pans are rusted; not too ...   12-06-2013 09:38 pm

there will be no oval shaped cylinder walls since they will be bored and honed.  Thanks Yelowdog and everyone else for your advice, the paper FROM ...   11-18-2013 10:38 pm

Thanks YELODOG, So it would be like most engines, piston to wall clearance between 0.003" to 0.0035".  Thanks a lot to all of you.  After about 10 ...   11-16-2013 09:14 pm

I just got the CR pistons from the store as I'm doing the 2.2 upgrade on my engine.  My question is:    1-  What would the ...   11-16-2013 02:47 am

My interest will probably go to a set of adaptors, if they're made in something like 4x100 the quantity of styles, size and brands  of wheels ...   08-13-2005 08:44 pm

I've been using one method of flushing cooling systems that have work for me for the thirty three years that I have been a mechanic ...   08-13-2005 08:10 pm

Or we can plead with Greg and he can have some wheel adaptors (like the ones used with the big brakes) in say.....4x100 and we ...   04-28-2005 12:32 am

Same thing happened to me a while back and I asked the same question; the answer is Yes, that's the way it's in there, a ...   04-25-2005 08:49 pm

Remindme of......ME!!!!  My high school was (or maybe still is, I don't know) called Brooklyn H.S. of Automotive Trades, better known as Automotive H.S. in ...   04-21-2005 11:51 pm

There are only four things that your engine ( Lotus in a Jensen Healey) could burn and smoke like that.   1- oil; the smoke would be bluish ...   04-17-2005 05:06 pm

Mating the engine to the transmission after the engine is installed is very easy if:  1- the clutch is properly aligned   2- you tilt the engine ...   04-04-2005 12:56 am

HEY GUYS !!!!!  WHERE DID YOU GET THE SUPERPRO BUSHINGS FROM??????  Or better yet (I'll thank you for it) can you post or e-mail me the ...   03-31-2005 12:54 am

Pat  I'm planning to do the same thing to my car (reinforcement of the longitudinal members of the unibody) and would like to know if you ...   03-25-2005 01:37 am