| ||||
|
Posts by browndog9 | |
---|---|
41 posts | Showing posts 1-40 of 41 |
Miscellaneous > Recognize this parts? (3 replies - 1754 views) Looks like something that supports the radiator from tr 4 ... 07-26-2023 12:01 am Body & interior stuff > ignition key removal (4 replies - 2490 views) I just wanted to indicate that I solved the problem in case anyone ran into the same issue. With a mirror I saw that the ... 07-25-2023 11:58 pm Body & interior stuff > ignition key removal (4 replies - 2490 views) Followed your advice. once wheel and shround were removed everything works. Put all back on, still working !
Will drive around with 3/4 socket at ... 06-09-2023 11:17 pm Body & interior stuff > ignition key removal (4 replies - 2490 views) Little help in getting my ignition key out off the lock. It seems that the button to release the key is not operating properly. If ... 06-08-2023 08:32 pm Cooling > Alternate radiator for Mark I (5 replies - 3485 views) Oh for teenage fantasies. I would definitely had painted my mustang candy apple red. ... 03-20-2023 01:48 am Ignition > Ignition Switch (7 replies - 3992 views) Thankyou Bruce and Don and Greg. ... 09-21-2022 08:13 pm Ignition > Ignition Switch (7 replies - 3992 views) Wrong again. That is the ground that goes to the PB horn wire in the signal stalk. So I pulled the ignition pin connector hoping ... 09-21-2022 08:13 pm Ignition > Ignition Switch (7 replies - 3992 views) Have not checked , but after reviewing the wiring diagram, the ground supplies the PK wire which goes thru the LU door switch which then ... 09-21-2022 04:53 pm Ignition > Ignition Switch (7 replies - 3992 views) Understand I was not familiar with anything as far as physical connection when it first happened. It was something that just happened. Later I planned ... 09-21-2022 03:41 pm Ignition > Ignition Switch (7 replies - 3992 views) Well once again I found what I was looking for in the forum.
I had to figure out what it actually was and then found ... 09-20-2022 03:47 pm Ignition > Ignition Switch (7 replies - 3992 views) So I am pretty sure I dont' have a problem that has never hapened before, but I cannot find any reference to it in the ... 09-19-2022 07:27 pm Body & interior stuff > GT interior problems. (6 replies - 4738 views) Thank you I will ... 04-05-2022 12:03 am Body & interior stuff > GT interior problems. (6 replies - 4738 views) Redrqacer, that did not go as planned. Sorry to take so long but I think it would be best if I got the whole glovebox ... 04-04-2022 06:50 pm Body & interior stuff > GT interior problems. (6 replies - 4738 views) Yes. I will take a picture of what I have and let you decide what I need. And thanks for your advice on my JH ... 03-15-2022 02:25 am Body & interior stuff > GT interior problems. (6 replies - 4738 views) Just for the sake of completeness, I did manage to get the cigarette lighter back together while shedding a slight amount of blood.
I removed ... 03-14-2022 09:33 pm Engine & Transmission > T-Belt Eccentric Tensioner - Hex Size on Hub Drive. (8 replies - 6508 views) How do you procure said device ? ... 09-30-2021 06:54 pm Body & interior stuff > GT interior problems. (6 replies - 4738 views) So in the middle of covid, 2020, two of my buddies and I drove from Fort Worth to Prescott Arizona to buy a GT.
I have ... 06-22-2021 04:08 pm VIN Database for Jensen Healey & Jensen GT > VIN Database / Location Jensen GT (79 replies - 68122 views) Thanks. I have seen these very pictures before now.
They where taken when stored by the original owner.
He bought the car from the Beverly Hills ... 12-30-2020 02:02 pm VIN Database for Jensen Healey & Jensen GT > VIN Database / Location Jensen GT (79 replies - 68122 views) Driving 30369. Acquired 4-2020 ... 12-30-2020 01:13 am Intro Tech Board stuff > Frank Schwartz - RIP (5 replies - 6935 views) What a great guy. Hope you never have to change timing belts in heaven. ... 11-05-2020 08:51 pm Body & interior stuff > Paint Codes (9 replies - 14710 views) thanks ... 06-21-2020 02:45 am Body & interior stuff > Paint Codes (9 replies - 14710 views) I have just recently acquired a 76 GT. It is also pine green and I wondered if you were happy withe the results of your ... 06-16-2020 10:40 pm Electrical & Instruments > Speedo Cable (2 replies - 8912 views) Had to learn how to remove and attach speedo cable just recently.
The trick is to locate what to lightly squeeze to release the tab in ... 08-02-2019 10:26 pm Electrical & Instruments > Fritzy Tachometer (41 replies - 106080 views) I just redid my tach because of conversion to petronix 2. The job was made difficult only because some of the instructions were online and ... 07-12-2019 08:31 pm Accessories > Factory removable hard top (18 replies - 35956 views) It is July in Texas. There is nothing better than an early morning run with that top down. It makes all the work learning how ... 07-12-2019 02:12 pm Fuel Stuff > Necessary fuel lines (2 replies - 5539 views) Answered my own question by reading more forum postings.
Thanks CDA951 for posting about the one way valve.
I will place it just before the regulator and ... 03-24-2019 03:27 pm Fuel Stuff > Necessary fuel lines (2 replies - 5539 views) I failed to include that the PO switched to Dellorto carbs, hence the regulator and filter up front. ... 03-24-2019 03:06 pm Fuel Stuff > Necessary fuel lines (2 replies - 5539 views) So back in 2015 I purchased my Healey.
It has been a trip reading this forum determining if the thing was safe to drive. The ... 03-24-2019 02:33 pm Ignition > Should I rewire hot to coil ? (9 replies - 14385 views) In my infinite stupidity I failed to thank the guys of the present tense who most definitely helped to solve the mechanical puzzle on which ... 08-07-2018 01:22 pm Ignition > Should I rewire hot to coil ? (9 replies - 14385 views) Well, I got the rebuilt dizzy back from Greg. It was equipped with a pertronix 2. With the help of my buddy we researched information ... 08-06-2018 02:09 am Ignition > Should I rewire hot to coil ? (9 replies - 14385 views) There was oil inside the distr and after looking at the history of the car, Thanks Mr Fox, it was a rebuild put on not ... 05-28-2018 02:52 pm Ignition > Should I rewire hot to coil ? (9 replies - 14385 views) Decided to remove distr. Easier than I had imagined. The distr was covered in fresh oil which may have been my problem. It has igniter ... 05-26-2018 08:00 pm Ignition > Should I rewire hot to coil ? (9 replies - 14385 views) So, I am contacting the previous owner to get some more input and will get back. ... 05-15-2018 05:53 pm Ignition > Should I rewire hot to coil ? (9 replies - 14385 views) Thanks for the reply. A good summation of the posts I have read on the forum. It will be a busy day off Monday and ... 05-14-2018 12:39 pm Ignition > Should I rewire hot to coil ? (9 replies - 14385 views) I had a complete loss of power to plugs while traveling down the highway. I started tracing voltage and noticed that the wire supplying the ... 05-13-2018 10:12 pm Projects > Is this valued properly ? (9 replies - 17382 views) Thanks for the help.
I think I have worked a deal for the transmission. ... 10-15-2015 09:44 am Projects > Is this valued properly ? (9 replies - 17382 views) Ft Worth TX ... 10-12-2015 10:16 am Projects > Is this valued properly ? (9 replies - 17382 views) By the way, I wish I had asked this question three weeks ago as I now have another car for parts. Somebody needs to help ... 10-12-2015 02:35 am Projects > Is this valued properly ? (9 replies - 17382 views) Thanks for taking the time to reply and offer JH wisdom. ... 10-11-2015 04:13 pm Projects > Is this valued properly ? (9 replies - 17382 views) Thanks ... 10-11-2015 03:19 am | |
Current time is 09:35 pm | 1 2 |