Thanks. I had wondered if the timing mark extension could be cut back. I'll probably try filing it. I'll keep your skype contact info. ...   03-07-2014 07:55 pm

I appreciate all of these responses and such good advice. The issue with the early engine is that the ignition timing marks, by the crankshaft pulley, ...   01-22-2014 11:18 pm

Oh yah! I have already pulled the tensioner out as far as there is room, so I should have known that the stud would make no ...   01-22-2014 06:46 am

Thanks, Brett. I intend to buy the wrench from Delta. ...   01-22-2014 05:19 am

Dakota, That sounds quite ingenious, but scary. I wonder about putting a locking nut on the stud that goes through the excentric spindle into the block ...   01-22-2014 05:18 am

Thanks for your suggestions. What tool do you use to remove the bearings (or outer cover) while the unit is still on the car? The ...   01-21-2014 08:03 pm

I am trying to get 12465 ready for the road. Following advice from this site, I am replacing the timing belt and have intended ...   01-21-2014 12:46 am

My new '73 Jensen Healey has been sitting in a storage shed since the 90's, at least, but she's cleaning up nicely and will be ...   01-14-2014 01:47 am