Home 
Home Search search Menu menu Not logged in - Login | Register
> pearst

Profile Topics Posts
Posts by pearst
16 postsShowing posts 1-16 of 16

Suspension > Front suspension (53 replies - 97576 views)

Well now that I have obtained good access to that blasted bolt, all I managed to do was bend it. That sucker is really ...   04-27-2013 10:07 pm

Suspension > Front suspension (53 replies - 97576 views)

Greg Fletcher to the rescue! Greg sent me a very helpful email I wish to share: That bolt only comes out one way, even cutting ...   04-27-2013 10:04 pm

Suspension > Front suspension (53 replies - 97576 views)

Now what??? Passenger side apart successfully. On the driver side, the upper control arm bolt will not clear the exhaust manifold. Is this in ...   04-21-2013 12:06 am

Suspension > Front suspension (53 replies - 97576 views)

SUCCESS!! Thanks Guys!! ...   04-20-2013 07:33 pm

Suspension > Front suspension (53 replies - 97576 views)

Art DeKneef wrote: To answer your questions. 1. Yes. The strut is #50 in the picture. The round arm attaches to the lower control arm with ...   04-18-2013 02:45 pm

Suspension > Front wheel bearing/spindle question (9 replies - 20905 views)

francisg wrote: Help, I am looking for the Nilos part number usually stamped on the seal outer surface. Thanks FG One one side it says "V-ring V-38" On the ...   04-16-2013 10:41 pm

Suspension > Front suspension (53 replies - 97576 views)

Bigger pic. 115k is not enough..... If you have a shop manual, its section E, page 13. ...   04-15-2013 10:44 pm

Suspension > Front suspension (53 replies - 97576 views)

SportsRodder wrote: I have had my front suspension apart several times.  It is more dificult than the rear but doable. 1. Put the car on jackstands so you ...   04-15-2013 10:27 pm

Ignition > Distributor orientation (7 replies - 15708 views)

See pic for my current distributor orientation. Carbs are currently removed and being rebuilt. There is nothing attached to the vacuum advance hookup. ...   02-03-2013 07:42 pm

Brakes > front rotor thickness (17 replies - 40524 views)

Thanks fellas!  New pads and SS lines are already on the way.  Still considering whether I resurface those nasty looking rotors or not.  Will inspect ...   06-05-2012 12:46 pm

Brakes > front rotor thickness (17 replies - 40524 views)

Somewhat soft pedal with lots of fade. ...   06-05-2012 03:44 am

VIN Database for Jensen Healey & Jensen GT > 1975 VIN 20455 (0 replies - 6184 views)

1974 JH VIN#20455, (1?)20,332 miles, Originally blue, now Maaco Red (with overspray everywhere) black interior, 5 speed, good running condition, original engine. ...   06-03-2012 08:57 pm

Brakes > front rotor thickness (17 replies - 40524 views)

Your comments on the condition of my rotors would be appreciated. Too far gone to have cleaned up? If so, where to buy ...   06-03-2012 08:48 pm

Engine & Transmission > Missing belt - what's this accessory? (4 replies - 8990 views)

Car runs *pretty* good. A little rough when cold and also hesitates a bit under harder acceleration. It may just need a tune ...   06-03-2012 08:40 pm

Engine & Transmission > Missing belt - what's this accessory? (4 replies - 8990 views)

Yep. 1975. Not needed to operate then? ...   06-02-2012 07:28 pm

Engine & Transmission > Missing belt - what's this accessory? (4 replies - 8990 views)

Sorry for the newbie question. New to Jensens. ...   06-02-2012 06:54 pm


 Current time is 02:35 pm
 


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems