| ||||
|
Posts by cavanbound | |
---|---|
12 posts | Showing posts 1-12 of 12 |
Body & interior stuff > Hunting for finisher strip - wood panel lower border, black plastic (10 replies - 17208 views) Frank-
Thanks for the reply- I think Art's already got the parts I need shipped out to me under separate cover, but thank you again. I'll ... 06-25-2011 02:08 pm Body & interior stuff > Hunting for finisher strip - wood panel lower border, black plastic (10 replies - 17208 views) Art -
I think you're right, and I'm crossed up on the part numbers - I can't find the 92713 part on the Delta diagram, so ... 06-22-2011 01:20 am Body & interior stuff > Hunting for finisher strip - wood panel lower border, black plastic (10 replies - 17208 views) Hoping to find someone with a parts car that can sell me the finisher strip below the left-most panel (LHD car) - this is the ... 06-19-2011 04:09 am Body & interior stuff > Complete dash removal for dashpad install (5 replies - 13764 views) Ron-
Good advice - my Madera wood will be here in a few days as well, so I'll likely couple the two projects (dashcover/wood fascia).
Thanks again ... 05-22-2011 12:59 am Body & interior stuff > Complete dash removal for dashpad install (5 replies - 13764 views) I looked through the postings and tech articles, and based on the tech article (http://www.jensenhealey.com/tech/dash/dashcap.html), I'm planning to pull my entire dash to get a ... 05-21-2011 04:11 pm Body & interior stuff > Madera Concepts wood fascia (8 replies - 17031 views) John-
Looks very nice - reinforces my purchase. Looks like you might've chosen Carpathian Elm as I did?
One item I'm missing from my trim - the ... 05-06-2011 01:28 pm Body & interior stuff > Madera Concepts wood fascia (8 replies - 17031 views) Thanks Ross. Interesting that they told me only to send the cigarette lighter cowl, but I wasn't actually placing an order - just trying to ... 05-05-2011 02:22 am Body & interior stuff > Madera Concepts wood fascia (8 replies - 17031 views) Guys-
I'm considering swapping out the tired stock faux wood in my JH 18082 for the Madera Concepts wood fittings. Has anyone got experience installing that ... 05-04-2011 05:22 am Body & interior stuff > Mesh screen over the air scoop, below front bumper (4 replies - 9903 views) Thanks Art - much appreciated. I'm not doing anything on it in the next week, but would appreciate any additional info you can offer. Regards ... 03-11-2011 04:35 am Body & interior stuff > Mesh screen over the air scoop, below front bumper (4 replies - 9903 views) My 74 JH is missing the mesh screen that should cover the front air scoop. Delta has one listed in their catalog (Air Scoop Mesh ... 03-11-2011 02:17 am Ignition > I messed up my timing changing out the timing belt (distributor) (2 replies - 9173 views) Brett - thanks much. I pulled the dizzy cap, it was well over 90 but probably not as much as 180 degrees out of alignment ... 09-07-2010 01:15 am Ignition > I messed up my timing changing out the timing belt (distributor) (2 replies - 9173 views) Guys-
I just purchased 18082, imported into Minnesota from Missouri. The car ran very well, but I embarked on the timing belt change, among other maintenance ... 09-04-2010 03:26 am | |
Current time is 02:32 am |