Anyone have access to one of the octagonal wheel centers that cap the old dealer installed Dunlop wire wheels? My car (19946) has had ...   07-29-2024 08:43 pm

All - Got the new OEM style needle valves put in and the carbs installed (again) and as of this writing no more leaks. Still ...   05-20-2024 10:39 pm

jh092 - Checked the fuel pump pressure after the final fuel filter just before the carb T fitting and it measures just under 3 psi (with ...   05-16-2024 10:37 pm

noomg - It may be coincidental but this problem has existed since I installed the Grosse valves (I've had the car since 1980 and the Grosse ...   05-13-2024 11:02 pm

Thanks for the replies folks. Given that I had no problems with the original style needle valves I think I will try replacing ...   05-12-2024 03:25 pm

I've read all the existing posts regarding fuel leaks from the vent hole on the face of the Stromberg carbs but mine is still a ...   05-08-2024 05:30 pm

JH 19946, excellent running condition, 5 speed, original wire wheels, engine #B74 12 10 972, Boca Raton, Florida, USA. Purchased in 1980 in Garden Grove, CA. ...   05-25-2008 11:27 pm

In case anyone else needs to do this... I took the driveshaft to Driveshafts Unlimited in Arnold, MO and they managed to disassemble the joint behind ...   07-24-2005 01:24 am

Googled the name and found harry.e.weddington@usace.army.mil   I'm 99% sure this is the same e-mail address I used long ago. ...   07-11-2005 12:32 am

I was the guy (or one of the guys) that asked you about the lug nuts, Greg.   I did purchase a set of the lug ...   07-10-2005 11:58 pm

Sorry in advance if this is a dumb question, but I've never disassembled a driveshaft before (or most other parts of the car for that ...   07-10-2005 10:00 pm