Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Suspension > Wheel bearings

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Wheel bearings  Rating:  Rating
AuthorPost
 Posted: 08-29-2010 02:41 pm
  PM Quote Reply
1st Post
subwoofer
Member
 

Joined: 04-01-2008
Location: Sandefjord, Norway
Posts: 617
Status: 
Offline
 Does anyone have the SKF or Timken part numbers for the front wheel bearings? If I can find the correct bearings locally, that will save me a lot of time, money and hassle.

--
Joachim
Back To Top PM Quote Reply  

 Posted: 08-29-2010 02:58 pm
  PM Quote Reply
2nd Post
Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 Timkin outer cup, LM11710  / cone LM11749

Inner cup L44610  /  Cone L44649

Tensioner Bearing SKF 414871A (just happened to be on the same sheet of paper)

Brett
Back To Top PM Quote Reply

 Posted: 08-29-2010 03:30 pm
  PM Quote Reply
3rd Post
subwoofer
Member
 

Joined: 04-01-2008
Location: Sandefjord, Norway
Posts: 617
Status: 
Offline
 That is the cam belt tensioner? Good info to have!

--
Joachim
Back To Top PM Quote Reply  

 Posted: 08-30-2010 01:46 pm
  PM Quote Reply
4th Post
Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 yes it is, but I dont recall if it is the early 2 bearings together, or the later larger single one. A price check would tell the larger is significantly more.
Back To Top PM Quote Reply

 Posted: 09-01-2010 07:32 pm
  PM Quote Reply
5th Post
subwoofer
Member
 

Joined: 04-01-2008
Location: Sandefjord, Norway
Posts: 617
Status: 
Offline
 Got hold of two sets of SKF L44649/610 and one set LM11749/710 (still have one set of those from earlier) from the local industrial parts supplier, they had them in stock. Will have a go at changing them this weekend.

But, just to make sure: I am supposed to press the cups in until they bottom out against the diameter step, correct? Bearings are expensive enough when you need them in a hurry that I don't want to ruin them from stupid mistakes...

--
Joachim
Back To Top PM Quote Reply  

 Posted: 09-02-2010 01:46 pm
  PM Quote Reply
6th Post
Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 That's correct, they need to be "seated", also if you clean up the hub you will notice a cut out in the seat that makes getting the old ones out easier by tapping from behind.
Back To Top PM Quote Reply

Current time is 08:24 pm  
> Jensen Healey & Jensen GT Tech > Suspension > Wheel bearings Top


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems