View single post by subwoofer | |||||||||||||
Posted: 09-01-2010 07:32 pm |
|
||||||||||||
subwoofer
|
Got hold of two sets of SKF L44649/610 and one set LM11749/710 (still have one set of those from earlier) from the local industrial parts supplier, they had them in stock. Will have a go at changing them this weekend. But, just to make sure: I am supposed to press the cups in until they bottom out against the diameter step, correct? Bearings are expensive enough when you need them in a hurry that I don't want to ruin them from stupid mistakes... -- Joachim
|
||||||||||||
|