| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Installing Instrument Panel | Rate Topic |
| Author | Post |
|---|
| Posted: 02-15-2006 08:57 pm |
|
1st Post |
|
Jim DeClerck Member 
|
When I removed my instrument panel 2 metal plates fell out. They were apparently attached between the top of the panel and the under side of the dashboard and held in place by the two panel attachment screws. What is the function of these plates? How should they be included in the reinstallation of the panel?
|
||||||||||||||
| |||||||||||||||
| Posted: 02-16-2006 03:58 am |
|
2nd Post |
|
Arvin Appelman Member
|
The metal plates were glued to the foam in the dash and are used to hold the dash panel in place. The foam deteriates and the plates rust. I don't know of any way to reinstall the plates into the dash. I used 1/4 plywood in place fo the plates. I had to cut the foam to countersink the wood. I installed them with silicon glue and small screws angled into the foam. When reinstalling the dash panel don't over tighten these screws. Arvin Appelman 19492
|
|||||||||||||
| ||||||||||||||
| Posted: 02-17-2006 09:15 am |
|
3rd Post |
|
Jim DeClerck Member
|
Thanks, Arvin. That sounds like a practical solution. And plywood doesn't rust!
|
||||||||||||||
| |||||||||||||||
| Current time is 01:34 am | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Installing Instrument Panel | Top |
