| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| fuse box | Rate Topic |
| Author | Post |
|---|
| Posted: 09-09-2022 08:09 pm |
|
1st Post |
|
jomac Member
|
Has anyone replaced the current 3 fuse box with the new 4 fuse box part number 93065. looking how you did it. my current one is needs replacement.
|
||||||||||||||
| |||||||||||||||
| Posted: 09-13-2022 02:37 am |
|
2nd Post |
|
Art DeKneef Member
|
I replaced the fuse box on one of the cars with an after-market 4-fuse box with push fuses of the proper rating. Using the wiring diagram I spilt the one fuse with the most wires into two. Relatively easy job to do. Slightly hard because you don't have much wire to pull on and I needed to redo the ends for the new fuse box.
|
|||||||||||||
| ||||||||||||||
| Posted: 12-16-2022 01:25 am |
|
3rd Post |
|
jomac Member
|
Correction the fuse box I got from martinrobey.com is a 3 fuse and same as the original with slight changes. I plan cutting the bottom wiring harness that goes thru the grommet and adding A multiple pin connector before the fusebox allows for service later. The 3 fuse wiring I will transfer the current wires to the new terminals. If wires are short I'll splice in a connector. Looking at the wiring diagram there shouldn't more the 5 wires to deal with. So I would have 2 connectors behind the fusebox . When servicing the fusebox if needed you can remove it , slide it along the grommet wiring cable far enough to disconnect the connectors behind the fusebox. Will see how it works out this month.
|
||||||||||||||
| |||||||||||||||
| Current time is 04:11 am | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > fuse box | Top |
