| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| 907 engine in work stand | Rate Topic |
| Author | Post |
|---|
| Posted: 11-26-2013 07:33 pm |
|
1st Post |
|
Barthol Member
|
Hi, I have bought an engine stand as shown on the attached photo. The engine have to be fixed by 4 bolt using the threads where the gear box normally attaches to the engine. I am concerned that the break forces will break the alu casting on the engine. have som of you tried to mount a 907 engine in one of those stands, and if yes is there anything special I have to consider. I would really harte to damage the block :-) Best regards Kim Attachment: 15-370_l.jpg (Downloaded 144 times)
|
||||||||||||||
| |||||||||||||||
| Posted: 11-26-2013 07:53 pm |
|
2nd Post |
|
roland11a Member
|
I've had mine on the same type of stand for months and regularly move it round the Garage to make space. The 907 is a very light engine. If you want i can send a photo of how its attached.
|
|||||||||||||
| ||||||||||||||
| Posted: 11-26-2013 09:08 pm |
|
3rd Post |
|
subwoofer Member
|
Try to mount it so the mount points are as far from eachother as possible and you should be fine. That reduces the pull/push on the mount points. The case is strong enough, I had one fully built hanging on the stand for quite a while without any problem. The VW boxers weight almost the same and the official engine stand only has two bolts... -- Joachim
|
||||||||||||||
| |||||||||||||||
| Posted: 11-27-2013 05:25 am |
|
4th Post |
|
Barthol Member
|
Thanks a lot guys, Roland11a if you can post an image it would be helpful. I guess that I have to stay away from the threads for the starter? MHV Kim
|
|||||||||||||
| ||||||||||||||
| Posted: 11-27-2013 08:28 am |
|
5th Post |
|
roland11a Member
|
ok will do. you can use the threaded holes for the starter if you use the correct size bolt into the exiting threads. Just remember the Lotus 907 engine is Metric
|
||||||||||||||
| |||||||||||||||
| Posted: 11-27-2013 09:43 am |
|
6th Post |
|
roland11a Member
|
I Forgot. The fly wheel has been removed. If you PM me your e mail address I can send better close up images if you like. Attachment: photo(7).JPG (Downloaded 124 times) Last edited on 11-27-2013 09:45 am by roland11a |
|||||||||||||
| ||||||||||||||
| Posted: 11-28-2013 07:31 pm |
|
7th Post |
|
Barthol Member
|
Roland11a , Thanks a lot for the photos, I will go ahead and use my stand. Got a 2.2 engine I need to work on:-)
|
||||||||||||||
| |||||||||||||||
| Current time is 10:29 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > 907 engine in work stand | Top |
