 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 10-31-2013 |
| Location: | Denmark |
| Posts: | 67 |
| Status: |
Offline
|
I have bought an engine stand as shown on the attached photo.
The engine have to be fixed by 4 bolt using the threads where the gear box normally attaches to the engine.
I am concerned that the break forces will break the alu casting on the engine.
have som of you tried to mount a 907 engine in one of those stands, and if yes is there anything special I have to consider.
I would really harte to damage the block :-)
Best regards
Kim
Attachment: 15-370_l.jpg (Downloaded 144 times)