| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Radio block off plate | Rate Topic |
| Author | Post |
|---|
| Posted: 12-16-2005 11:11 pm |
|
1st Post |
|
edward_davis Member 
|
Does anyone have a picture of a factory radio blockoff plate? Is it possible to buy these or reproductions? Are there any good alternatives? I've decided that I don't need my radio, since my JH sings me such a sweet song on her own. Can't hear the radio over the engine/ road noise anyway. Also, antenna block-offs?
|
||||||||||||||
| |||||||||||||||
| Posted: 12-17-2005 03:10 am |
|
2nd Post |
|
Art DeKneef Member
|
I've not seen any block-offs for the radio or antenna. For the radio, I would imagine creating something wouldn't be too difficult. Finding an elegant mounting solution may be a little tricky. Maybe something that would press fit into the tuner holes for easy removal when you change your mind later. The antenna part would be more difficult. First, you would need to configure a cover plate with a screw stud on the back, find an appropriate gasket, and then tighten it from inside the fender. A press fit cover probably could be made, but ensuring the gasket was tight to prevent water from getting inside might be a concern. Of course you could weld in a piece of metal to seal it off forever. Or until you change your mind. Art
|
|||||||||||||
| ||||||||||||||
| Posted: 12-17-2005 04:52 am |
|
3rd Post |
|
Tony Hollart Member
|
I looked for a simple blanking plate to cover over where the radio was to go. In the end I did put in a radio but have not bothered about connecting it up to anything. A radio fits the holes and firms the whole panel up. An old radio is hardly appealing to anyone to pinch, when you see the type of electronics that is available in modern vehicles it is bewildering. As you pointed out a Jensen not only sings, it can move you to singing, you dont need GPS becuase you have 360 degrees of vision. Tony H.
|
||||||||||||||
| |||||||||||||||
| Posted: 12-17-2005 04:34 pm |
|
4th Post |
|
Mark Rosenbaum Member 
|
Here's the only photo I have on the radio blanking plate. Nothing that shows the back side, I'm afraid. According to the photo title, it measures 6.375" horizontally by 1.75" vertically and is made of aluminum. Apparently there are two pins on the back. Presumably these would press into sockets of some sort that, perhaps, would have pressed into the holes for the radio's knobs. Attachment: radio blanking plate 6.375x1.75 alum 2 pins.jpg (Downloaded 77 times)
|
|||||||||||||
| ||||||||||||||
| Current time is 03:47 am | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Radio block off plate | Top |
