View single post by Art DeKneef
 Posted: 12-17-2005 03:10 am
PM Quote Reply Full Topic
Art DeKneef

 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
 I've not seen any block-offs for the radio or antenna. For the radio, I would imagine creating something wouldn't be too difficult. Finding an elegant mounting solution may be a little tricky. Maybe something that would press fit into the tuner holes for easy removal when you change your mind later.

The antenna part would be more difficult. First, you would need to configure a cover plate with a screw stud on the back, find an appropriate gasket, and then tighten it from inside the fender. A press fit cover probably could be made, but ensuring the gasket was tight to prevent water from getting inside might be a concern. Of course you could weld in a piece of metal to seal it off forever. Or until you change your mind.

Art