| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| fender gaskets | Rate Topic |
| Author | Post |
|---|
| Posted: 09-15-2016 01:58 pm |
|
1st Post |
|
Bfitz241 Member 
|
I did a search, but may not have used the right terms so please be kind.. Anyway, took the left front fender {in the USA} or wing if you will {in the UK} off to address a massive undercoating mess. Glad I did as I found a plastic gasket between the wing and the sill that had been riveted to the sill. Is this a correct part? I looked at the diagrams and didn't see it. Anybody use something specific at this junction? I'm thinking about using some thin, very thin, butyl tape to act as a seal...seam sealer proper will harden too much and silicone sealers can contain acids that attach the paint and steel. Thanks for opinions and input....progress is being made
|
||||||||||||||
| |||||||||||||||
| Posted: 09-15-2016 02:04 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
The non corrosive gasket is there to keep the wing and rccker separate so that any moisture will drain off, having it sealed creates a rust prone area. Same as the rear wing dogleg.
|
|||||||||||||
| ||||||||||||||
| Posted: 09-15-2016 02:25 pm |
|
3rd Post |
|
Bfitz241 Member
|
so it does belong there....good to know..thanks
|
||||||||||||||
| |||||||||||||||
| Posted: 09-15-2016 05:33 pm |
|
4th Post |
|
redracer Member
|
The GTs and I would guess some of the '75s had that plastic piece, but the earlier cars did not(not sure what the VIN # that started on)
|
|||||||||||||
| ||||||||||||||
| Current time is 08:24 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > fender gaskets | Top |
