| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Water Pump Test | Rate Topic |
| Author | Post |
|---|
| Posted: 07-18-2017 11:30 pm |
|
1st Post |
|
Spaceman Member 
|
Finally got my car to run, oil pressure problems etc, but now I don't see any water running thru the upper hose? Also my temp gauge doesnt' show any movement. When I squeeze the hose before the thermostat, I can hear air move thru, I think the thermostat is stuck open. So why do I not see water pumping thru the system? I wonder if I have an air bubble, or the impeller is gone? Any Ideas?
|
||||||||||||||
| |||||||||||||||
| Posted: 07-19-2017 02:10 am |
|
2nd Post |
|
redracer Member
|
If the "upper hose" you are referring to is the one to the radiator, the water should NOT flow through it until the 165 or 180 degree Farenheit is acheived, assuming you have one of the 2 standard thermostats. The 2 stage thermostat will gradually close the hole back to the pump and simultaneously open to the radiator. As for the "NO" temperature, how long did the engine run? Sometimes it can take 10 minutes(especially in wintertime) to reach the "OPEN" thermostat settings. I am assuming that all fluid have been set to their proper levels? bruce
|
|||||||||||||
| ||||||||||||||
| Posted: 07-19-2017 10:50 pm |
|
3rd Post |
|
Spaceman Member
|
I haven't run it for more than 4 minutes, as I fear overheating, interesting info on the 2 stage thermostat, yes I have been reading the thermostat must be closed for the engine to heat up properly. Once I fix the carb leaky gasket, I will run it for 10 minutes, and test the water temp gauge. thanks Bruce
|
||||||||||||||
| |||||||||||||||
| Posted: 07-19-2017 11:33 pm |
|
4th Post |
|
redracer Member
|
whoa...leaky carb.? That rear carb sits right over the starter--it's called instant fire(hope you brought the marshmallows). Please have a fire extinguisher ready if you are unsure of the carbs; can't tell you how many cars have been burned up this way.
|
|||||||||||||
| ||||||||||||||
| Posted: 07-19-2017 11:39 pm |
|
5th Post |
|
Spaceman Member
|
I have had 2 on hand for every test, first the oil seal went, then carb #1 overfilled and spewed, and then carb 2 had no fuel. Replaced float valve, now the gasket leaks. My car was damaged by fire a long time ago, everything was melted. Wire harness has completely melted together. Air box, wiper bottle, rad overflow, gone. And both carbs were melted, and seized. But I was lucky, and found another Jensen Healey owner with a second parts car. I might mount one under the hood with a quick release inside the cockpit. cheers D.
|
||||||||||||||
| |||||||||||||||
| Posted: 07-20-2017 05:13 pm |
|
6th Post |
|
Spaceman Member
|
leak appears to be fixed, now to run it up to temp and test the temp gauge. Also need to pull the dash out and change all the bulbs, and replace the oil gauge, it blew up when my oil relief valve jammed, and oil pressure was past 100.
|
|||||||||||||
| ||||||||||||||
| Current time is 01:02 am | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Water Pump Test | Top |
