| Moderated by: Greg Fletcher | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Mondial1 Member 
|
Can the Tach be removed from the gauge cluster by itself? I need to install the circuit board to correct the Pertronix issue. Thanks! Mark. |
|||||||||
|
answerman Member
|
Easy peasy. Had to look but I found my writeup on this from a while back... http://www.jensenhealey.com/forums/view_topic.php?id=1524&forum_id=5&jump_to=14170#p14170 Make sure that when you look at the post, also look at the post right below the one I'm linking to as it has a better picture. Last edited on 07-01-2016 05:37 am by answerman |
|||||||||
|
Mondial1 Member
|
Thanks answerman! I'm a big fan of doing as little as possible to get the job done. Glad I asked before removing the whole gauge cluster. Thanks again!! |
|||||||||