| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Tach only removal ? | Rate Topic |
| Author | Post |
|---|
| Posted: 06-30-2016 09:02 pm |
|
1st Post |
|
Mondial1 Member 
|
Can the Tach be removed from the gauge cluster by itself? I need to install the circuit board to correct the Pertronix issue. Thanks! Mark.
|
||||||||||||||
| |||||||||||||||
| Posted: 07-01-2016 05:35 am |
|
2nd Post |
|
answerman Member
|
Easy peasy. Had to look but I found my writeup on this from a while back... http://www.jensenhealey.com/forums/view_topic.php?id=1524&forum_id=5&jump_to=14170#p14170 Make sure that when you look at the post, also look at the post right below the one I'm linking to as it has a better picture. Last edited on 07-01-2016 05:37 am by answerman |
|||||||||||||
| ||||||||||||||
| Posted: 07-01-2016 02:39 pm |
|
3rd Post |
|
Mondial1 Member
|
Thanks answerman! I'm a big fan of doing as little as possible to get the job done. Glad I asked before removing the whole gauge cluster. Thanks again!!
|
||||||||||||||
| |||||||||||||||
| Current time is 05:42 pm | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Tach only removal ? | Top |
