| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Oil Pressure/Temp T Fitting | Rate Topic |
| Author | Post |
|---|
| Posted: 06-18-2013 04:04 am |
|
1st Post |
|
cgillies Member
|
I broke the fitting that connects the T piece to the Oil Chamber on the block. I ordered the fitting but it seems to be the wrong thread (the thread on the T is OK) I found that the thread in the chamber is M8 x 1.25. and of course the T is different M10 x 1.0. Where can I get a fitting please?? Regards Colin - new JH owner in Austin TX
|
||||||||||||||
| |||||||||||||||
| Posted: 06-18-2013 04:20 pm |
|
2nd Post |
|
Art DeKneef Member
|
Unfortunately I don't have an answer. Have you tried Delta? That is not a stock piece that came with the car as far as I know. So some previous owner made the modification to allow for the oil temp gauge. You could think about tapping the metal piece that the tee screws into.
|
|||||||||||||
| ||||||||||||||
| Posted: 06-19-2013 12:51 am |
|
3rd Post |
|
cgillies Member
|
Thank you Art - I guess I am set to tap the casing...appreciate the answer Colin
|
||||||||||||||
| |||||||||||||||
| Posted: 06-19-2013 01:49 pm |
|
4th Post |
|
Brett Gibson JH5 20497 Member
|
Last I knew the fittings were all NPT, National Pipe Thread.
|
|||||||||||||
| ||||||||||||||
| Posted: 06-19-2013 06:10 pm |
|
5th Post |
|
cgillies Member
|
Thanks Brett I will check that out. Metric bolts fit but it may be just coincidence.....
|
||||||||||||||
| |||||||||||||||
| Posted: 06-20-2013 06:14 am |
|
6th Post |
|
subwoofer Member
|
1/8"NPT and M10x1.0 are close enough in pitch and diameter that they can be interchanged, but watch for leaks. NPT threads are conical, M threads are not. Both are used for various sensors. -- Joachim Last edited on 06-20-2013 06:15 am by subwoofer |
|||||||||||||
| ||||||||||||||
| Current time is 08:47 am | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Oil Pressure/Temp T Fitting | Top |
