| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Choke knob | Rate Topic |
| Author | Post |
|---|
| Posted: 06-16-2005 01:58 am |
|
1st Post |
|
paulbrown Member
|
Any of you fine people know how to remove the choke knob from the JH front panel? I'm trying to remove the panel and for the life of me, I can't figure out how to get that knob off! Any clues gratefully received! Cheers, Paul
|
||||||||||||||
| |||||||||||||||
| Posted: 06-16-2005 02:49 am |
|
2nd Post |
|
George Member
|
Had this same problem recently. You have to unbolt the cable from up front at the carbs and pull it thru. I guess some people replace the mounting so it is off to the side of the panel, but I reallyy didn't have any trouble pulling mine and then rethreading it. Ended up doing it a few times. Mine is a solid wire rather than braided (not sure if it is stock), which would,I am sure, make the rethreading much more difficult.
|
|||||||||||||
| ||||||||||||||
| Posted: 06-16-2005 03:05 am |
|
3rd Post |
|
paulbrown Member
|
Hey George.....many thanks! Sure appreciate you giving me that info, I'll give it a go. Cheers,
|
||||||||||||||
| |||||||||||||||
| Posted: 06-16-2005 03:44 pm |
|
4th Post |
|
Mark Rosenbaum Member 
|
There's a trick which is often of use. Before pulling the cable through the firewall, tie a 6-foot-long string to the engine end of the cable. Untie this string after the cable is through the firewall and before removing the cable and heater console from the car. When reinstalling things, re-tie the string to the cable, and use the string to pull the cable into the engine bay.
|
|||||||||||||
| ||||||||||||||
| Posted: 06-16-2005 03:53 pm |
|
5th Post |
|
paulbrown Member
|
Thanks Mark, that's a really good tip. Most appreciated. Cheers, Paul
|
||||||||||||||
| |||||||||||||||
| Current time is 05:07 pm | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Choke knob | Top |
