Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Ignition > VOLTAGE FLUCTUATION

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
VOLTAGE FLUCTUATION  Rating:  Rating
AuthorPost
 Posted: 08-29-2006 01:17 am
  PM Quote Reply
1st Post
73healey
Member
 

Joined: 03-13-2006
Location: Lodi, California USA
Posts: 25
Status: 
Offline
WHEN DRIVING WITH THE LIGHTS ON THE VOLT GAUGE WILL BEGIN SHOWING 12-13 VOLTS. AFTER A BIT THE NEEDLE SLOWLY DROPS TO THE RED AND THE IGNITION LIGHT COMES ON. A FEW MINUTES LATER THE NEEDLE ON THE VOLT GAUGE WILL BEGIN TO RISE AGAIN TO THE 12-13 VOLT RANGE. IS THIS SOMETHING TO WORRY ABOUT? IF SO, WHAT SHOULD I LOOK FOR?

THANKS,

JIM 10646

Back To Top PM Quote Reply  

 Posted: 08-29-2006 07:19 pm
  PM Quote Reply
2nd Post
Mark Rosenbaum
Member


Joined: 03-12-2005
Location: Kingman, Arizona USA
Posts: 532
Status: 
Offline
Most likely this is due to a defective alternator.  Occasionally a faulty battery will give the same symptoms (generally, an intermittent cell).  For Delco alternators, this sometimes occurs if the sense wire on the alternator plug is loose or broken.

Before replacing any parts, I would check the following:
  • Using a hydrometer, measure specific gravity of electrolyte in each battery cell.  This is usually a definitive test to identify a faulty battery.
  • Fan belt should take up a roundish shape (not triangular or oval) if removed from engine, and should be properly tensioned when installed.
  • Battery connections must be tight and have bright shiny metal-to-metal contact.  Usually it is necessary to brush or scrape both terminals and connectors.
  • Clean wiring terminals and contacts on starter solenoid.
  • Clean wiring terminals and contacts on alternator (check both ends of the plug).
  • Clean wiring terminals and contacts inside plastic junction box located on main cable between battery and starter solenoid.
"Clean" in the above means metal that is free from any oil or corrosion.  Usually a bit of wire brushing followed by degreasing with carburetor cleaner will suffice.

Back To Top PM Quote Reply

 Posted: 08-29-2006 10:35 pm
  PM Quote Reply
3rd Post
73healey
Member
 

Joined: 03-13-2006
Location: Lodi, California USA
Posts: 25
Status: 
Offline
Thank you Mark. I will start with your list

Jim

Back To Top PM Quote Reply  

Current time is 12:08 pm  
> Jensen Healey & Jensen GT Tech > Ignition > VOLTAGE FLUCTUATION Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems