| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Dellorto DHLA 45 | Rate Topic |
| Author | Post |
|---|
| Posted: 02-02-2011 02:30 am |
|
1st Post |
|
jarnol123 Member
|
I need to replace 2 of my idle mixture screws...anyone know how to remove them? Also, as many people have done before me, I took out the pin that the float pivots on and broke the very brittle piece that holds the pin in. I read on another forum that this can be fixed at a good jewelry repair shop. Has anyone done this or am I resigned to buying a whole new top cover? If so, does anyone have one? Thanks for the help.
|
||||||||||||||
| |||||||||||||||
| Posted: 02-02-2011 03:22 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Let me know how you make out with getting the casting repaired I did the same thing but was able to drill a tiny hole and loop a small wire to hold the pin in place. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 02-02-2011 03:51 pm |
|
3rd Post |
|
jarnol123 Member
|
Brett, no problem I have ordered the Des hammill book but until it arrives I don't know how to get the idle mixture screws out (I have to replace 2 of them). I want to order them but I need to know which ones i have as there are 4 different versions for the DHLA I believe. Anyone who knows how to do this please let me know.
|
||||||||||||||
| |||||||||||||||
| Posted: 03-26-2011 04:08 pm |
|
4th Post |
|
jarnol123 Member
|
Hey Brett, I asked s jewelry repair shop to try and laser weld the piece back on but they couldn't do it. can you take me through how you did it, ie with the wire?? I can't find any of these top casting pieces anywhere...very frustrating. thanks!
|
|||||||||||||
| ||||||||||||||
| Posted: 03-27-2011 03:14 pm |
|
5th Post |
|
Brett Gibson JH5 20497 Member
|
Eurocarb LTD. at this site should have another cover for you but I think when I checked it was pretty $$$ thats why I thought I would try the wire loop. http://www.dellorto.co.uk It's been a couple of years and seems to be holding up, the piece that broke on mine still held the pin at a level hieght, thats a must. I will sketch it out and e-mail you privately what mine looks like and how I did it. Brett
|
||||||||||||||
| |||||||||||||||
| Posted: 03-27-2011 04:40 pm |
|
6th Post |
|
jarnol123 Member
|
thanks brett
|
|||||||||||||
| ||||||||||||||
| Current time is 08:31 pm | |
| > Jensen Healey & Jensen GT Tech > Carburetors > Dellorto DHLA 45 | Top |
