Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Dellortos Mounts  Rate Topic 
AuthorPost
 Posted: 10-15-2009 02:25 am
  PM Quote Reply
1st Post
Jensen Healey
Super Moderator


Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
I'm attempting to reduce the gasoline smell  in the cockpit and removed the carbs since one has an epoxy repair in the accelerator pump bowl. There was some evidence of minor leakage there at the gasket but the JB Weld repair has held up well for five years.

The soft mounts, however, have totally failed in this time and this appears to have been letting fuel past the O-rings. I ordered a new set of thackery washers (steel spring washers) so they will never fail again.

My winter projects include finally installing the 107 cams so I replaced the 33mm chokes with 35mm in anticipation of sucking more fuel through the system.

Now I'm in search of some 104 pulleys...

Kurt

JH 13148

Back To Top PM Quote Reply  

 Posted: 04-04-2010 10:29 am
  PM Quote Reply
2nd Post
907heaven
Member
 

Joined: 04-01-2010
Location:  
Posts: 17
Status: 
Offline
Kurt,  I probably have some 104 pullies - are you after the square tooth type? 

GARRY

Back To Top PM Quote Reply

 Posted: 04-04-2010 04:15 pm
  PM Quote Reply
3rd Post
Jensen Healey
Super Moderator


Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
Hi Garry,

Welcome! I remember at least one at least one article by you in the club magazine some years back. It's great to see you on the forum.

I have completed the work with pulleys from Mike Taylor.

All that's left to do is take it to a local shop for a co reading. I drilled the idle jets to .56mm and installed .7 Idle jet holders from Eurocarb. The engine runs up (under the load of a 2nd gear start) through the rpm range with no flat spots but there's no urgency. I think it's still a tad lean.

Thanks for the offer,

Kurt Housh

JH 13148

Back To Top PM Quote Reply  

 Posted: 04-04-2010 09:37 pm
  PM Quote Reply
4th Post
907heaven
Member
 

Joined: 04-01-2010
Location:  
Posts: 17
Status: 
Offline
Hi Kurt,

it is nice to be welcomed to the forum, because my main interest is engines, I dip in and out of various clubs and forums; but because of the various Lotus models, I tend to only belong to one club / forum at any given time - It occured to me recently I was long overdue to look in on the JH community - while I've owned other Lotus models; I still have my 72 Healey - which is the car that originally got me into Lotus engines.

I am sure you'll enjoy your car with the new cam set up.

Regards

GARRY 

Back To Top PM Quote Reply

Current time is 12:26 pm  
> Jensen Healey & Jensen GT Tech > Carburetors > Dellortos Mounts Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems