| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| getrag 5 speed shift linkage | Rating: 
|
| Author | Post |
|---|
| Posted: 03-31-2007 04:23 am |
|
1st Post |
|
phil Member
|
Hi Have very sloppy stick. It can travel greatly unless you know by experience and feel. Does anyone have or know where I can get a parts list/blowup of the linkage and shift setup? I did drop whole assembly out when had car painted and replaced what I thought was the problem ( deteriorated bump/bush immediately under stick), but obviously wrong. Another thing I thought I corrected was an out-of-line driveshaft when I reassembled, but now I hit housing when I pull stick to me in order to find reverse ( again the getrag 5 speed..reverse is full to left and up). Suggestions??? Put shaft back where it was?? cut housing to accomodate?? Buy a ford?? Any and all advise appreciated. Phil
|
||||||||||||||
| |||||||||||||||
| Posted: 03-31-2007 09:47 pm |
|
2nd Post |
|
Jon Plowe Member
|
Phil Sounds like you have a problem, as from my experience the gear shift on the the Getrag is anything but sloppy, being stiffer/more awkward than the 4sp. The only time I had a sloppy gear shift with your symptoms was when the mounting bush just below the gear lever (the same as the one you replaced I think) came loose after only a few miles of use after having replaced it - cured with a nyloc nut. Things can appear okay as the nut on the transmission tunnel can be tight while the one underneath on the linkage is loose and visa versa, or both. Worth checking Jon
|
|||||||||||||
| ||||||||||||||
| Posted: 04-01-2007 01:58 am |
|
3rd Post |
|
phil Member
|
Thanks Jon; will take a look.
|
||||||||||||||
| |||||||||||||||
| Posted: 04-03-2007 05:11 am |
|
4th Post |
|
pbahr Member 
|
Phil, I sent you a PM - look for it. May help solve your problems. Pete PETE'S KITS
|
|||||||||||||
| ||||||||||||||
| Current time is 02:02 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > getrag 5 speed shift linkage | Top |
