| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Fuel Line | Rate Topic |
| Author | Post |
|---|
| Posted: 02-25-2007 07:14 pm |
|
1st Post |
|
kfsmith Member
|
Well, after 7 years in storage, I got the 73 j-h running again. I flushed the cooling system as well as the oil and all seemed well. I've done the back brakes and still need to replace the master cylinder. When I went out this AM there was a puddle of gas under the rear diff. On further inspection, years ago, a section of metal fuel line just after where it exits the trunk must have rotted off. It was fixed with a piece of tubing clamped over each end. I've now pulled the tank, removed all the wet insulation stuff and will be sending the tank out for cleaning and possibly epoxy sealing if needed. When this goes back together, what kind of fuel line should I be using? A hard line all the way up or is a rubber line acceptable tied into the good hard line?? Thanks in advance Kevin
|
||||||||||||||
| |||||||||||||||
| Posted: 02-25-2007 10:23 pm |
|
2nd Post |
|
Jim Ketcham Member
|
Hello Kevin, Rotted fuel line under the tank is unfortunately quite common. The original steel fuel line connects at two points with rubber hose. It connects to the fuel filter via a short rubber hose and again to the steel front line just forward of the trunk via a short rubber hose. I replaced mine with a stainless piece of tubing that I was able to bend up to match the original steel. I do not believe there is anything wrong with using the rubber fuel line in visibly accessible locations. Especially in the low pressure JH system. I would not use it under the tank or through the chassis or any other blind spots. Jim
|
|||||||||||||
| ||||||||||||||
| Current time is 02:22 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Fuel Line | Top |
