| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Installing Cams and Cam Gears -- question |
| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Installing Cams and Cam Gears -- question |
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Installing Cams and Cam Gears -- question | Rate Topic |
| Author | Post |
|---|
| Posted: 12-12-2006 01:10 pm |
|
1st Post |
|
Mark Kleimola Member
|
I am currently in the process of installing some 107 cams in place of base cams.. I noticed when disassembling the originals from the cam housings, that the gears had some sort of sealer on the end where the cam gear bolts run thru.. Is that a potential leak path or something else?? Certainly did not look like loctite for the bolt, in fact it was more like RTV or something... Anyway, what is everyone else doing when installing cams and the cam bolts? Also, what is the best pre lube to use on the bearing surfaces when assembling? Thanks in advance for any input.
|
||||||||||||||
| |||||||||||||||
| Posted: 12-12-2006 02:59 pm |
|
2nd Post |
|
Judson Manning Member 
|
Mark, The cams are 'gun-drilled' all the way through to carry oil from the front journal the journals 2-5. The bolt that retains the cam sprocket and the bolt that hold the rear spacer, are both points for leakage past the threads. I tend to use a little blue hylomar on the threads, but you could use orange silicone (very sparingly) as well. Any commercially available 'Assembly Lube' (or in a pinch, STP oil additive) will provide plenty of protection. The 'book' only suggests dumping a quart of oil on the assembly before bolting on the cam covers. Judson
|
|||||||||||||
| ||||||||||||||
| Posted: 12-12-2006 03:29 pm |
|
3rd Post |
|
Jensen Healey Super Moderator 
|
Dump a quart of oil? That would be pretty funny on the exhaust side! I use Red Line assembly lube but moly is just fine. Kurt
|
||||||||||||||
| |||||||||||||||
| Posted: 12-12-2006 08:15 pm |
|
4th Post |
|
Mark Kleimola Member
|
Thanks guys! Now I can move onto figuring out the shim thicknesses I need, etc...
|
|||||||||||||
| ||||||||||||||
| Posted: 12-13-2006 05:57 pm |
|
5th Post |
|
smcmanus Member 
|
WOW! Exact same question I had about the silcone on the cam cog bolts. I just started putting mine together this morning. I probed the holes and thought the bolt holes had solid bases. If it is "gun drilled," should I clean out the holes with a cleaning rod? What caliber brush is best? Thanks Steve
|
||||||||||||||
| |||||||||||||||
| Current time is 01:53 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Installing Cams and Cam Gears -- question | Top |
