> Jensen Healey & Jensen GT Tech > Engine & Transmission > Adding Dowels to the Bearing Housing to Block Studs |
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Adding Dowels to the Bearing Housing to Block Studs |
| Moderated by: Greg Fletcher | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Dan Eiland Member
|
Where can I purchase the correct dowels for the Main bearing housing to block studs? I want to add them to all 10 studs to stiffen the bottom end before I have the engine line bored for my 2.2L conversion. I guess I will try DB tomorrow and see if they have them. |
|||||||||
|
Dan Eiland Member
|
Since no one responded I called Dave Bean and purchased what I needed. Just a FYI if anyone else was interested. |
|||||||||
|
Joel Member
|
Dan: Just a quick thanks for posting all your info! I'm HOPING to start on the same project in 6 months or so and really appreciate all your imput. Before I start I'll make sure to drop you a line and pick your brain. Right now everything seems to be running fine on the stock motor so I'm just taking my time collecting the parts so I can get my spare up and running. Thanks again! |
|||||||||
|
Dan Eiland Member
|
Joel, I hope that is what this place is all about, sharing what we know with those who need it and asking those who know for assistance when we need it. I have taken a lot of digital photos as I proceed. If you would like to see something before you jump in just let me know and I'll post it here. |
|||||||||