| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Why a 2-pc drive line on a 5-speed? | Rate Topic |
| Author | Post |
|---|
| Posted: 07-28-2024 01:37 pm |
|
1st Post |
|
Jh092 Member
|
The center support bearing on my drive line is shot and needs to be replaced. A common fix is to replace the original with a 1-piece drive shaft similar to the one used on the 4-speed gearbox. This seems like a logical fix since it worked on the 4-speed. What was the reasoning to use the 2-piece unit on the 5-speed? There were no performance upgrades to the engine with 5-speed. There was a cost to use the 2-piece unit and the decision to use it would have to have fulfilled a requirement. My car has been stroked out to 2.2l. I am wondering if the 2-piece shaft is a better candidate to handle the extra engine torque and power.
|
||||||||||||||
| |||||||||||||||
| Posted: 07-28-2024 07:35 pm |
|
2nd Post |
|
noomg Member
|
Jh092, Keep in mind that reaching into the LBC parts bins the two piece may have been chosen because it fit rather than to fill a specific need. Delta sells a one piece for the 5sp it's probably an aftermarket unit built by a local driveshaft shop with parts supplied by Delta so I'd say there's no problem using a one piece. You can buy one from delta or just take your 2-piece to a local D/S shop and have them build you one.
|
|||||||||||||
| ||||||||||||||
| Posted: 07-28-2024 08:18 pm |
|
3rd Post |
|
Jh092 Member
|
I don’t think that is the case. They already had a drive line that would have to be ordered either longer or shorter to meet the need and the cost differential would be minimal. But, the added cost for the 2 pc d/s is 2 cv joints, a central bearing, and additional support brackets. Although it does lose 1 u-joint in the design I think it may have to do with trying to compensate for a possible change in the pinion angles with the new transmission. Does a 1 pc d/s work? Yes. Reading thru this forum, there are a lot of conversions out there and they all seem to be working fine.
|
||||||||||||||
| |||||||||||||||
| Current time is 03:19 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Why a 2-pc drive line on a 5-speed? | Top |
