| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Clutch lever pins | Rate Topic |
| Author | Post |
|---|
| Posted: 09-19-2023 03:10 pm |
|
1st Post |
|
redracer Member
|
When installing a new clutch assembly, check the two pins that engage the throw out bearing for signs of wear on the front surface that rubs against the slot in the bearing. Using a chisel/punch/whatever, rotate the two pins about 90 degrees to essentially give you a new surface' If you have to loosen the pins, just tack weld them in the new position. Attachment: J-H clutch lever pin rotation small.jpg (Downloaded 22 times)
|
||||||||||||||
| |||||||||||||||
| Posted: 09-19-2023 03:11 pm |
|
2nd Post |
|
redracer Member
|
pins to be rotated Attachment: J-H clutch lever pin rotation.jpg2 small.jpg (Downloaded 22 times)
|
|||||||||||||
| ||||||||||||||
| Posted: 09-19-2023 03:11 pm |
|
3rd Post |
|
redracer Member
|
"new" position Attachment: J-H clutch lever pin rotation.jpg2.jpg3 small.jpg (Downloaded 23 times)
|
||||||||||||||
| |||||||||||||||
| Current time is 06:03 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Clutch lever pins | Top |
