| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Oil Cooler Hose I.D. ? | Rate Topic |
| Author | Post |
|---|
| Posted: 10-03-2019 05:13 pm |
|
1st Post |
|
Steve Duncan Member
|
Anyone know the inside diameter of the hoses that go to and from the oil cooler?
|
||||||||||||||
| |||||||||||||||
| Posted: 10-03-2019 10:32 pm |
|
2nd Post |
|
redracer Member
|
without actually cutting one open, the connectors coming out of the hose are 1/2' while the short fittings to the sandwich are 9/16". hope this may help, bruce
|
|||||||||||||
| ||||||||||||||
| Posted: 10-03-2019 10:49 pm |
|
3rd Post |
|
Steve Duncan Member
|
Thanks, but I'm hoping someone has cut one open so I can get an accurate measurement . I am planning on splicing in a preluber and would like to get the fittings in advance.
|
||||||||||||||
| |||||||||||||||
| Posted: 10-25-2019 04:05 pm |
|
4th Post |
|
Steve Duncan Member
|
I can confirm (through cutting into two separate junked sets) that there are at least two possible IDs. 1/2" and 5/8"
|
|||||||||||||
| ||||||||||||||
| Current time is 09:30 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Oil Cooler Hose I.D. ? | Top |
