| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| 5 speed trans | Rate Topic |
| Author | Post |
|---|
| Posted: 10-06-2017 09:09 pm |
|
1st Post |
|
jomac Member
|
My 5 speed trans sticks in reverse and 1st gear when cold. After warm up it’s fine. What causes this ... trans fluid type, a clutch component, I have new clutch cable and clutch is adjusted to specs. Or is this typical for the getrag 5 speed trans. I am currently using bmw pentosin mtf2 sae 75w-80 api gl-4 oil. Last edited on 10-08-2017 10:24 pm by jomac |
||||||||||||||
| |||||||||||||||
| Posted: 10-07-2017 02:27 am |
|
2nd Post |
|
Jensen Healey Super Moderator 
|
I suspect the shift linkage. It is prone to heavy wear in the metal on metal bushings and joints. Try soaking the area with spray lube before a cold start. This could identify the problem. Good luck, Kurt
|
|||||||||||||
| ||||||||||||||
| Posted: 10-12-2017 10:30 am |
|
3rd Post |
|
gmgiltd Member
|
One suggestion for lubricating the linkage is to use aerosol spray motorcycle chain grease. I use Castrol which is very liquid (like WD40) from the can and intended to penetrate the chain links. The solvent soon evaporates leaving a very water resistant grease that sticks like the proverbial s*** to a blanket. If it lubes and clings to a bike chain for 3000 miles it should have no issues with the linkage. Gordon
|
||||||||||||||
| |||||||||||||||
| Current time is 10:14 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > 5 speed trans | Top |
