| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Cylinder head oil gallery feed mod | Rating: 
|
| Author | Post |
|---|
| Posted: 03-10-2014 03:09 am |
|
1st Post |
|
bora450 Member
|
Per the attached article, there is too much oil going to the camshafts and buckets. Restricting the feed passage provides more oil to the crankshaft. Is this a desirable modification for a 2 liter street engine or only done to racing engines? If I should do this, now is the time. Thanks, Claus Attachment: Oil gallery feed mod.jpg (Downloaded 75 times)
|
||||||||||||||
| |||||||||||||||
| Posted: 03-10-2014 12:47 pm |
|
2nd Post |
|
roland11a Member
|
Hi I was advised to do this by a reptutable engine builder in the UK. Apparently the original design allows to much oil into the head and starves to bottom end of oil pressure. The other mod advised is to drill a very small hole in the oil pump housing to enable the pump to prime much quicker reduce the delay in oil pressure on start up. I've just done this to an early engine rebuilt around a later lotus block. Not got to run it as yet though.
|
|||||||||||||
| ||||||||||||||
| Posted: 03-10-2014 04:29 pm |
|
3rd Post |
|
Jensen Healey Super Moderator 
|
I did this to my street engine. Since I could only find hardened set screws, I annealed it before drilling the 1/8" hole. Kurt
|
||||||||||||||
| |||||||||||||||
| Posted: 03-11-2014 04:24 am |
|
4th Post |
|
bora450 Member
|
OK guys. That's what I'll do tomorrow. Thanks, Claus
|
|||||||||||||
| ||||||||||||||
| Current time is 01:09 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Cylinder head oil gallery feed mod | Top |
