| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Realign crank with camshafts | Rate Topic |
| Author | Post |
|---|
| Posted: 03-08-2014 02:10 am |
|
1st Post |
|
Art DeKneef Member
|
In getting ready to start the car I'm rebuilding discovered the water pump was leaking. So after replacing the water pump and gasket I also replaced the front cover seal and gasket. So I had to install the crank pulley again being careful not to tighten to tightly until everything was together again. One of my 'young' helpers thought they would help by tightening the bolt on the pulley for me. It moved but I don't know by how much. Right now the timing belt and distributor cam wheel are off So the question is what's the best way to make sure the crank aligns with the cam shafts so I can get the timing belt together and try starting it without bending valves and causing any damage? And I was getting close to seeing if I could get it running again.
|
||||||||||||||
| |||||||||||||||
| Posted: 03-10-2014 12:54 pm |
|
2nd Post |
|
roland11a Member
|
If the crank has turned, and I guess by not much its not caught the valves. Just carefully turn it back untill the markings on the timing belt sprockets line up again. If you take the plugs out so the engine turns easily you will feel if the piston contacts the valves if you turn iy carfully. Also you will see when No 1 is approching TDC
|
|||||||||||||
| ||||||||||||||
| Current time is 03:37 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Realign crank with camshafts | Top |
