| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Speedo Cable | Rate Topic |
| Author | Post |
|---|
| Posted: 03-20-2012 03:07 pm |
|
1st Post |
|
Paul Koehler Member 
|
Just finished the change over from 4-speed to 5-speed, and getting ready to install the 5-speed speedometer cable into its housing on the Getrag unit and noticed something was missing. Is there a drive or linkage that goes between the end of the cable and its insertion point on the transmission? What am I missing?
|
||||||||||||||
| |||||||||||||||
| Posted: 03-22-2012 02:27 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Paul, if memory serves me correctly the cable just goes in the side of the trans. and a small bolt holds it in I dont recall any gear drives and such on the side, if you want me to I will go up were the my car is stored and have a look to be sure, let me know. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 03-22-2012 05:36 pm |
|
3rd Post |
|
MikeIsotech Member 
|
Brett Gibson JH5 20497 wrote:Paul, if memory serves me correctly the cable just goes in the side of the trans. and a small bolt holds it in I dont recall any gear drives and such on the side, if you want me to I will go up were the my car is stored and have a look to be sure, let me know. I put mine in a few months ago and that's how I remember it. The end of the cable pushes into the gearbox and is held by a small locking bolt. Mike
|
||||||||||||||
| |||||||||||||||
| Current time is 10:35 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Speedo Cable | Top |
