| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Mounting engine to stand | Rate Topic |
| Author | Post |
|---|
| Posted: 12-13-2011 11:02 pm |
|
1st Post |
|
Bob 13902 Member
|
Got a used engine stand (no instructions) and this is my first use of one of these. Are there preferred bolt holes to use for the 4 attachment points or particular strength bolts?
|
||||||||||||||
| |||||||||||||||
| Posted: 12-15-2011 04:08 am |
|
2nd Post |
|
Art DeKneef Member
|
I don't know about preferred but I used the four that would fit my engine stand. I'm being lazy by not going out back in the dark to the car shed to look. I think they are attached to each side by the bottom of the head and the block by the starter and across from that. I believe I used Grade 5 hardware but either Grade 5 or 8 should be fine.
|
|||||||||||||
| ||||||||||||||
| Posted: 12-16-2011 01:58 am |
|
3rd Post |
|
Bob 13902 Member
|
thanks. my concern was that some of the attachment options near the starter "look" weaker and I didn't want to risk cracking any of the forging.
|
||||||||||||||
| |||||||||||||||
| Current time is 10:11 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Mounting engine to stand | Top |
