| ||||
| ||||
| Moderated by: Greg Fletcher | Page:   1 2 |
|
|||||||||||||
| Exhaust Header Replacement | Rating: 
|
| Author | Post |
|---|
| Posted: 08-12-2011 02:57 pm |
|
21st Post |
|
Jensen Healey Super Moderator 
|
Put the trans on a jack and pull off the trans mount. Then lower the jack while raising the front of the engine. I installed my engine with the header in place. Kurt
|
||||||||||||||
| |||||||||||||||
| Posted: 08-12-2011 04:00 pm |
|
22nd Post |
|
subwoofer Member
|
Mason Jones wrote:SpeedyMitch wrote:Any suggestions on how to replace the motor mounts without pulling the engine?You're not gonna want to hear this but... I think the header has to be off to be able to raise the engine enough to get the new mounts in. At least with the stock header you can replace the motor mounts without pulling the engine, you just have to do things in the right order! I have done it, so I know it can be done... You have to remove the right hand side motor mount first. Then you can shift the engine far enough to the right while tilting it to the right that the left motor mount comes off. Replace in opposite order. -- Joachim
|
|||||||||||||
| ||||||||||||||
| Posted: 08-12-2011 04:07 pm |
|
23rd Post |
|
SpeedyMitch Member 
|
Thanks guys - looks like I'll be spending some (more) quality time under the Jensen!
|
||||||||||||||
| |||||||||||||||
| Current time is 10:12 pm | Page: 1 2 |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Exhaust Header Replacement | Top |
