| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| replacement main bearings | Rating: 
|
| Author | Post |
|---|
| Posted: 01-12-2011 02:42 pm |
|
1st Post |
|
Dan (Florida) Member
|
I recently pulledd the engine out of my 73 in order to replace the rear main oil seal (rope) . This requires removing the crankshaft in order to fit the new seal which has to be trimmed to length after pressing into place. Upon removing the main bearing cradle and connecting rod caps and lifting the crank out I find the main and rod bearings were worn down to the copper backings. I miked the crank out and found it in very good shape and ordered a standard sized bearing set from the club store. The rod bearings went in fine and turned smoothly but the mains tightened up when the bolts were torqued down and would not turn. They plastigauged out to .003" and the bearings installed without the crank and tightened down were snap gauged and miked to the same. Still the crank would seize when tightened down. It ended up being the main bearing shells were too long and stuck up out of their races slightly. Trimming them down with a file solved the problem I hope, and theorize that when the engine was being machined at the factory the crankshaft align boring process got off center and took too much out of the block and too little out of the cradle. That being said I hereby cross all fingers and hope this ends the Christmas engine pulling jamboree. Im waiting for warmer weather for the engine start. ps this is the second rear main seal I have installed since this project started. The first came from Delta wrapped in paper with no instructions, (Fail) The second was an oem seal from Delta with instructions trimming gauges and lube. (better I hope). PPS During all this the water pump seal gave out . Not satisfied with the price of a replacement from Delta I found a pump seal from Pac-seal from a local plumbing supply that provided the ceramic ring that was needed for a vastly cheaper price. (This job is not for the inexperienced)
|
||||||||||||||
| |||||||||||||||
| Posted: 01-14-2011 02:13 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Dan, dont forget to use engine oil with ZDDP in it or the new stuff with just eat up that rope seal. And Good Luck, hope it works. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 01-15-2011 11:33 am |
|
3rd Post |
|
Dan (Florida) Member
|
thanks, the oil pump needs primed and radiator installed and it should light right off. But then it did before. I didn't know that about zddp. dan
|
||||||||||||||
| |||||||||||||||
| Posted: 06-18-2011 01:00 pm |
|
4th Post |
|
normv Member 
|
do you have the part number of the water pump seal ?? Thanks Norm Last edited on 06-18-2011 01:02 pm by normv |
|||||||||||||
| ||||||||||||||
| Posted: 06-18-2011 11:46 pm |
|
5th Post |
|
Dan (Florida) Member
|
not any more but it is a sprinkler / well / pool pump seal with a 1/2" shaft . About $20.00 us. aall I needed of the seal was the ceramic ring. The worst part was getting it all spaced out on the shaft. hth Dan
|
||||||||||||||
| |||||||||||||||
| Current time is 11:13 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > replacement main bearings | Top |
