| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| bell crank clutch actuation | Rating: 
|
| Author | Post |
|---|
| Posted: 01-03-2011 03:08 am |
|
1st Post |
|
superk83 Member
|
I was wondering if any one has photos of the z-bar, bell crank setup... I don't have the parts to use as reference and will need some sort of visual aid when it comes time to fab this up... unless I'm mistaken and it's cable actuated? Any pointers, photos and descriptions are appreciated!
|
||||||||||||||
| |||||||||||||||
| Posted: 01-13-2011 10:22 am |
|
2nd Post |
|
superk83 Member
|
I've recently found found out Jensen clutch is cable actuated... pointers as to how the cable is routed...?
|
|||||||||||||
| ||||||||||||||
| Posted: 01-13-2011 10:31 pm |
|
3rd Post |
|
subwoofer Member
|
Comes out by the brake servo, then loops around the front of the engine. You can't miss it. -- Joachim
|
||||||||||||||
| |||||||||||||||
| Posted: 01-13-2011 10:38 pm |
|
4th Post |
|
superk83 Member
|
You're probably right, if I had a JH in front of me, I couldn't miss it... As I only have an engine and transmission, it's a little fuzzy...lol! Any pics?
|
|||||||||||||
| ||||||||||||||
| Posted: 01-14-2011 03:22 am |
|
5th Post |
|
pbahr Member 
|
Here's A photo of the front left bottom of engine. Send an email to peteb01@comcast.net, and I'll send you a couple more. What's a Z-bar? What's a bell crank? YELODOG Attachment: ClutchCableRouting 3.JPG (Downloaded 69 times)
|
||||||||||||||
| |||||||||||||||
| Posted: 01-14-2011 04:18 am |
|
6th Post |
|
superk83 Member
|
So that's what that's for...! I kept thinking some kind of idler pulley... Email sent!!!
|
|||||||||||||
| ||||||||||||||
| Posted: 01-14-2011 04:32 am |
|
7th Post |
|
superk83 Member
|
Oh...! Z-bar and Bell crank are kind of interchangeable terms for the same thing, but basically, it a tube with two arms welded perpendicular to the tube to actuate the clutch in older vehicles... Older Camaros had them... There is a "ball" that screws into the rear of the engine block on the drivers side that the tube slips over... When you push the pedal in, it pushes one arm on the tube, which is rotating on the ball in the block, pushing the other arm on the tube towards the clutch throw out fork, attached by a threaded rod for adjustment as the clutch wears... Pretty sweet setup for close quarters, but hell on the calf if you've got a heavy clutch...lol! http://www.novas.net/forums/showthread.php?p=74265 There's a nice sized exploded view about half way down the page or so.. the kink in the horizontal tube is NOT a 90' kink, just a little "chicane" if you will...
|
||||||||||||||
| |||||||||||||||
| Current time is 07:59 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > bell crank clutch actuation | Top |
