| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Rebuilding a GT engine without the airpump stuff |
| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Rebuilding a GT engine without the airpump stuff |
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Rebuilding a GT engine without the airpump stuff | Rate Topic |
| Author | Post |
|---|
| Posted: 03-18-2010 05:46 am |
|
1st Post |
|
Art DeKneef Member
|
Anybody do something like that? What did you do for the holes in the head for the tubes on the exhaust side? I am taking off the original cast exhaust off the GT engine and replace with a set of Delta headers. Unfortunately some of the tubes above the exhaust broke while trying to remove the bolts holding them to the head. Didn't have any room to get to the upper exhaust bolts. Since I'm pretty sure this tube piece is pretty extinct, I'm wondering if just plugging the eight holes will work or does something else need to be done because of the fitting with the small diameter tube that goes into the head.
|
||||||||||||||
| |||||||||||||||
| Posted: 03-18-2010 02:31 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Art, my head used to have those air holes and the PO filled them years ago with what look's like JB Weld, haven't had any issue's. I would imagine any good epoxy metalic filler would work, I'd stick with a metalic though just so you get expansion and contraction similiar to the head. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 03-18-2010 07:27 pm |
|
3rd Post |
|
Art DeKneef Member
|
Thanks. If thats the case I might just find some thin head bolts and use them or maybe just aluminum weld the holes shut.
|
||||||||||||||
| |||||||||||||||
| Posted: 04-02-2010 12:17 pm |
|
4th Post |
|
907heaven Member
|
European engines didn't use the air pump, but some still had the drillings, they are normally blocked off with 1/8" BSP threaded plugs. They have tapered threads and tighten up as you thread them in. If they are hard to source in the US, let me know and I could post you some over. Regards GARRY
|
|||||||||||||
| ||||||||||||||
| Current time is 02:41 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Rebuilding a GT engine without the airpump stuff | Top |
