Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Rebuilding a GT engine without the airpump stuff

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Rebuilding a GT engine without the airpump stuff  Rate Topic 
AuthorPost
 Posted: 03-18-2010 05:46 am
  PM Quote Reply
1st Post
Art DeKneef
Member
 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
Anybody do something like that? What did you do for the holes in the head for the tubes on the exhaust side?

I am taking off the original cast exhaust off the GT engine and replace with a set of Delta headers. Unfortunately some of the tubes above the exhaust broke while trying to remove the bolts holding them to the head. Didn't have any room to get to the upper exhaust bolts.

Since I'm pretty sure this tube piece is pretty extinct, I'm wondering if just plugging the eight holes will work or does something else need to be done because of the fitting with the small diameter tube that goes into the head.

Back To Top PM Quote Reply  

 Posted: 03-18-2010 02:31 pm
  PM Quote Reply
2nd Post
Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
Art, my head used to have those air holes and the PO filled them years ago with what look's like JB Weld, haven't had any issue's.

I would imagine any good epoxy metalic filler would work, I'd stick with a metalic though just so you get expansion and contraction similiar to the head.

Brett

Back To Top PM Quote Reply

 Posted: 03-18-2010 07:27 pm
  PM Quote Reply
3rd Post
Art DeKneef
Member
 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
Thanks. If thats the case I might just find some thin head bolts and use them or maybe just aluminum weld the holes shut.

Back To Top PM Quote Reply  

 Posted: 04-02-2010 12:17 pm
  PM Quote Reply
4th Post
907heaven
Member
 

Joined: 04-01-2010
Location:  
Posts: 17
Status: 
Offline
European engines didn't use the air pump, but some still had the drillings, they are normally blocked off with 1/8" BSP threaded plugs.  They have tapered threads and tighten up as you thread them in.  If they are hard to source in the US, let me know and I could post you some over.  Regards GARRY

Back To Top PM Quote Reply

Current time is 02:23 am  
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Rebuilding a GT engine without the airpump stuff Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems