| ||||
Moderated by: Greg Fletcher |
|
Fuel type | Rating: |
Author | Post |
---|
Posted: 07-12-2013 02:34 pm |
|
1st Post |
Rob Rawe Member
|
J.H. shop manual has no reference to fuel octane rating that I can find. Can some one tell me what is recommended? JH #14120
|
||||||||||||||
|
Posted: 07-12-2013 06:57 pm |
|
2nd Post |
answerman Member
|
I'm pretty sure that my owners manual specifies a minimum of 91 octane. Plus, for whatever it's worth, "premium" is usually ethanol free, which is important in a car of the JH's vintage as the ethanol can cause havoc with the fuel system and seals and such.
|
|||||||||||||
|
Posted: 07-16-2013 10:08 am |
|
3rd Post |
subwoofer Member
|
The stock JH 907 has next to no compression (8.5:1) and still fast combustion chambers, so octane rating is not likely to be an issue. I run a higher compression 907 (9.4:1) from a Lotus Eclat and see no issues on regular 95RON. My VW flat-4 in the family barge has 10.5:1 compression, slower chambers and still runs with no issues on 95RON... But beware of alcohol content, since it eats gaskets and fuel lines if they are not compatible, and fuel lines from the 70's are most likely not! -- Joachim
|
||||||||||||||
|
Posted: 07-16-2013 10:34 pm |
|
4th Post |
Jim Ketcham Member
|
Remember that the JH manual specifies RON. In the US the octane rating on the pump is (R+M)/2., that is, the average of the Research Octane Number ( RON) and the Motor Octane Number (MON). Since the MON for typical fuels is about 8 numbers lower than the RON, US "regular" at 87 (R+M)/2 should meet the 91 RON requirement as specified in the JH manual. JH fuel lines are steel and should be okay with ethanol. Aluminum and certain elastomers do not seem to like ethanol, but I have not experienced any problems with E10 (10% ethanol) which is what we see in the US (in all grades) in non-compliance areas.
|
|||||||||||||
|
Current time is 04:57 am | |
> Jensen Healey & Jensen GT Tech > Fuel Stuff > Fuel type | Top |