| Moderated by: Greg Fletcher | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
roverman Member
|
Is it possible this series of motors share a common crankshaft , but different strokes ? I'm working with a crank manufacturer for potential of forged stroker cranks, for this series of engines. Anyone have interest in such ? Thanks, roverman. |
|||||||||
|
Jensen Healey Super Moderator 
|
Garry Kemp has done at least a 2.5 liter IIRC. Sounds expensive! |
|||||||||
|
roverman Member
|
I suppose "expensive" is a relative term ? Isn't the cast 2.2L crank approx. $1,200, In the JHPS store ? Forged stroker will likely be less, based on volume. Regards, Art G. |
|||||||||
|
Jensen Healey Super Moderator
|
Sounds like a great project, Art! It sure makes for good reading! Will you be using custom con rods and pistons? |
|||||||||
|
roverman Member
|
Yes, based on what strokes prove compatable with potential of existing forging. Likely a shorter/lighter rod and less compression height on piston. Regards, Art G. |
|||||||||