| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Windshield | Rate Topic |
| Author | Post |
|---|
| Posted: 08-15-2007 02:03 pm |
|
1st Post |
|
Dan (Florida) Member
|
The piece of stainless trim that fits around the base of the windshield fits close to the glass at the edges of the windshield but is almost one half inch away from the glass at the center of the windshield and filled with sealer. this makes the gap between the trim piece and the rear edge of the hood much smaller where the wiper arms won't hide behind the hood. The wiper arms as well will not climb up over the trim when they park. I am assuming that the wiper arms in a properly set up car are concealed behind the hood. Does anyone else have this big gap or has my windshield been "bodgered" by an amatuer. I would hate to think that the factory did this. One other question, my drivers side wiper arm is straight and the passenger side has a slight bend to it that makes the wiper blade not park neatly. It kind of sticks out at the lower edge. Aren't both arms supposed to be straight??
|
||||||||||||||
| |||||||||||||||
| Posted: 08-16-2007 12:47 am |
|
2nd Post |
|
Steve Jarvis Member
|
The gap on my windshield is approx 1/8" at the outside edge and slightly under 1/2" in the middle. The wiper blade arms are similar to your description. The passenger side blade is parallel to the edge of the hood when parked. I'll see if I can't load a picture to go with the explanation. Last edited on 08-21-2007 01:37 pm by Steve Jarvis |
|||||||||||||
| ||||||||||||||
| Posted: 08-16-2007 04:17 am |
|
3rd Post |
|
Jensen Healey Super Moderator 
|
Mine is the same. Kurt
|
||||||||||||||
| |||||||||||||||
| Posted: 08-22-2007 01:57 pm |
|
4th Post |
|
Dan (Florida) Member
|
Removed the stainless strip below the windshield this weekend and cleaned out all of the old sealer and refit the strip to see what was making it stick out so far (half inch at the center) . There is a perpendicular section of this strip that fits under and supports the bottom of the glass which in my opinion is a little wide. This holds the stainless molding strip a good half inch away from the glass (way too much). I trimmed this back to around 1/4" and refit resulting with a flush fit at the edges and 1/4" in the center. The wipers will actually park on the strip out of sight . There was also a rubber gasket that I eliminated that held the strip off and sealed around the screw heads that was not replaced. That area was sealed with windshield sealer as well. The whole area looks better with the smaller gap at the windshield base.
|
|||||||||||||
| ||||||||||||||
| Current time is 07:02 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Windshield | Top |
