colinw59
Member
|
The two door hinges pass through two rectangular holes in the front of the door, and are secured to the door by three bolts per hinge. These bolts are only accessible by removing the door panel. Loosening these bolts will enalble you to adjust the door horizontaly, verticaly (a little) and by rotation. By loosening the bolts that attach the hinges to the car, you will be able to adjust the door verticaly and inwards. When I do this, I work in one plane at a time and loosed all but 2 of the bolts (1 per hinge), with all the bolt at the other end of the hinge tightened. These two remaining bolts are nipped up just tight enough to enable adjustment but requiring some effort. If all bolts are loosened the door will float all over the place and it will be difficult to bolt into place while holding the door steady.
Often though some final tweeking will be required as the door may move a tad when all the bolts are finaly tightened. This whole process can take 1-2 hours per door believe it or not, and is done a series of adjustments that improve the alighment slightly as you go. Perfection here is not attainable however unless the door opening is exactly the same shape and size as the door, less the clearance of 3/16"- 1/4" for each of the three sides. Be aware of this, and accepting of it, unless you want to chase your tail all day long! As a foot note, to make this job easier I used Allen wrench bolts instead of hex head ones where the hinges attach to the car. Good luck, Colin
http://jhppg.com/gallery/74-Jensen-Healey-15851
|
