| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Insulation | Rate Topic |
| Author | Post |
|---|
| Posted: 06-01-2006 05:08 am |
|
1st Post |
|
Paul Koehler Member 
|
After driving for several hours in 85* weather on Sunday, and experiencing that "warm-fuzzy" feeling from the transmission tunnel, I thought to myself, "I gotta insulate this puppy". Has anyone done before and after measurements, on the effectiveness of the insulation, in reducing cockpit temps? A subjective assessment will also do! PK
|
||||||||||||||
| |||||||||||||||
| Posted: 06-01-2006 03:18 pm |
|
2nd Post |
|
Jensen Healey Super Moderator 
|
I found that most of the heat comes up around the gear shift. I attached an inner boot made from plastic sheeting and packed fiberglass insulation around the shifter before installing the leather boot. Problem solved. Kurt
|
|||||||||||||
| ||||||||||||||
| Posted: 06-02-2006 02:29 pm |
|
3rd Post |
|
colinw59 Member 
|
From the factory there is only open air (hot air) between the shifter aperture in the transmission tunnel and the leather shifter boot. It seemed to be bad engineering to me. So I cut a piece of 1" thick foam, oversize by 1" in both directions, and then cut a 1/2" deep slit/undercut around the perimeter. The foam was eased into place and retained by the sheet metal around the aperture seating into the slit/undercut. I also used sound deadening material over the tunnel and other areas of the cockpit. Heat soak is very minumal even over the 85 deg. weather we had last weekend, and the car runs quietly. http://jhppg.com/gallery/74-Jensen-Healey-15851
|
||||||||||||||
| |||||||||||||||
| Current time is 02:11 am | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Insulation | Top |
