| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Bolt Sizes | Rate Topic |
| Author | Post |
|---|
| Posted: 01-30-2006 05:16 pm |
|
1st Post |
|
Greg Fletcher Administrator 
|
Can anyone tell me what size nuts are used to mount the side marker lights to the inside of the body? I beleive these are the same as what holds the rear trim bits to the body. I'm also trying to figure out what size bolt I need for the front bumper flasher lens. Any ideas? Thanks!
|
||||||||||||||
| |||||||||||||||
| Posted: 01-31-2006 01:28 am |
|
2nd Post |
|
Jim Ketcham Member
|
Side marker lights use 6-32 nuts. For steel bumper vehicles, The front bumper flasher unit uses 8-32 nuts. The front bumper flasher lens uses 6-32x1 1/4 inch long machine screws.
|
|||||||||||||
| ||||||||||||||
| Current time is 02:57 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Bolt Sizes | Top |
